Honda Civic 8 (FK/FN, 2006–2011) / Type R FN2: 52 mm gauge pod for the ashtray – no drilling

Description

For the Honda Civic 8 hatchback (FK/FN, 2006–2011), including the Type R FN2: the pod plugs into the ashtray (coin tray) of the centre console and holds one 52 mm gauge, e.g. oil temperature or oil pressure on the K20.

• A U-shaped foot with crush ribs clamps in the well, the base plate rests on top. Nothing is drilled.
• Tilted 45° toward the driver.
• The cable runs through the hollow stand and the base plate down into the well.
• Two foot orientations (long side across or fore-aft) – check on the car first.
• Prints without supports.

File the crush ribs if needed; too loose: felt tape on the foot. Check the +0.4 mm bore with the test ring.

Dimensions

Dimensions of the default variant in print orientation.

Material and temperature

Shaded location: PETG is sufficient, ASA is the more robust choice. PLA is unsuitable in a car – it starts to soften at about 55–60 °C.

Print orientation: Front face on the bed, cup pointing up; the foot lies on the bed as well.

Guide: PETG or ASA in a car?

Safety notice

The pod sits in the centre console clear of the airbag zones. It must not obstruct the gear lever, handbrake or cup holder – check in every gear. Install at your own risk. Never mount in an airbag deployment zone, never cover controls, never restrict the view. Follow the material and temperature advice. Add-ons may affect the type approval of the vehicle (§ 19 StVZO in Germany); keep edges in the head and knee area rounded (UN Regulation No. 21).

Not an original part. No affiliation with the vehicle manufacturers named; make and model names only indicate fitment.

Well size from an ashtray replacement (Thingiverse 2879814, CC BY). Orientation of the well and LHD/RHD equality not sourced. Curtain airbags standard – they do not affect the centre console.

What's included

• toleranz-testring-52mm.stl – Tolerance test ring
• honda-civic-8-aschenbecher-gauge-pod-52mm_quer_gauge52.stl – STL – print-ready mesh
• honda-civic-8-aschenbecher-gauge-pod-52mm_quer_gauge52.3mf – 3MF – with print profile
• honda-civic-8-aschenbecher-gauge-pod-52mm_quer_gauge52.step – STEP – editable in CAD
• honda-civic-8-aschenbecher-gauge-pod-52mm_laengs_gauge52.stl – STL – print-ready mesh
• honda-civic-8-aschenbecher-gauge-pod-52mm_laengs_gauge52.3mf – 3MF – with print profile
• honda-civic-8-aschenbecher-gauge-pod-52mm_laengs_gauge52.step – STEP – editable in CAD

You will also need

• 1 × M3 set screw or self-tapping M3 screw, 8–10 mm

Printing

1. Print the tolerance test ring first and test-fit the gauge.
2. Print in ASA, ABS or PETG, 0.2 mm layers, 4 walls, 20 % infill, no supports. No PLA.

Installation

1. Remove the ashtray insert.
2. Feed the cable from the top through the stand and base plate into the well, insert the gauge, tighten the set screw hand-tight.
3. Press the pod into the well with the gauge facing the driver.

FAQ

Version 1.0.0, updated 2 November 2026 · SKU GP-HO-CIVIC8-ASH-1X52